RACE TECH HI-PERFORMANCE SPRING KIT
ATV SPORT SPRING KIT CAN-AM RENEGADE 

<IP_QFSKS06.doc>               E Rios-Race Tech ã 8-8-2010

INCLUDES qty 2 of each: Main Spring, Center Spring, Top Spring, NPL Collar, STD Go-Between and Step-Cut Go-Between.

TOOLS REQUIRED: Service Manual, Vise with Soft Jaws TMVJ 065 or equivalent, TSPA 01 Preload Adjusting Tool or Spanner Wrench, ¼” Flat Blade Screwdriver and TSSM 01 Sag Master or Calipers.

DIGITAL VALVING SEARCH (DVS) printout: See DVS at www.racetech.com for your custom spring setup specs.

 

Support the front of the ATV securely; remove front shocks per the procedure in your service manual.  Install the Race Tech Spring Kit as follows:

Note: Click on the images to enlarge.

Disassembly

D1  Clamp Shock into a vise with Soft Jaws.

D2  Loosen Lock Ring.

 

D3  Remove all spring preload by unscrewing the collars. Use a Spanner Wrench if necessary.

D4  Use a small Screwdriver or similar tool to gently pry the Bottom-Out Bumper away from the end of the Shock. 

D5  Remove the C-Clip Spring Retainer by pulling the Spring down and sliding the Clip out from under the Bumper Cup.

D6  Remove the stock Spring.

The stock Preload Collar and Lock Ring will be used with the Race Tech Spring Kit. It is a good idea to clean and grease the threads on both the Preload Collar and Lock Ring before installation of the Spring Kit.

 

 Assembly
 

A1  Install the NPL Collar (single flange) with the long end of the flange facing towards the bottom of the shock. Install the flat Spacer (no flanges) onto the NPL Collar.

A2  Install the softer of the two Springs (this Spring will have a thinner wire diameter) over the NPL Collar.

 

A3  Install the Step Cut Go-Between Collar. The step on the inside diameter of the Go-Between goes towards the threaded portion of the shock body; this provides proper clearance for the collar to pass over the threads during this operation. If the step does not go towards the threads the collar could get stuck causing damage.

 

A4 Install the Center Spring.
              

A5  Install the Go-Between. The Go-Between is reversible for tuning purposes. Running the shorter end into the Secondary Spring will cause the spring set to cross over onto the Main Spring later. Running the long end into the Secondary Spring will cause the spring set to cross over onto the Main Spring sooner. This tuning option can be used to affect things such as body roll and proper front end traction.

A6  Install the Main Spring.

A7  Install the Stock C-Clip Spring Retainer.

Preload Setup

P1  Refer to the DVS Specs from racetech.com.

P2  Adjust the Preload Collar to set the preload.

P3  Gently tighten the Lock Ring against the Preload Collar being careful not to change the Preload.

P4  Repeat procedure for the second shock.

 

Note:

Preload is the distance the spring assembly is compressed initially at full shock extension.

Measure the overall length of the spring assembly with no tension. Subtract the Preload (from the DVS Spec) to calculate the installed length of the Spring assembly. Then use the Preload Adjusting Collar to adjust the spring set the amount specified in the DVS specs.